SI,
I tried using Quick Mask (Q Button) and it worked fine. What process are you using or what’s not happening. Are you in RGB mode? This may be a problem.
Let’s know what’s going on.
regards
Mark
Funny, I tried it again and it DIDN’T work but I inverted the selection which wasn’t masked and it looked great. there may be something strange going on. What is it you are trying to do SI?. BTW, i’m in the UK so it’s near bedtime at 1.00am
Regards
Mark
It would not work in one image but would work in another. Don’t know what I was doing wrong (other than sitting here to long).
Anyway, thanks for the quick response.
I am trying to apply the Ripple effect on an oval selection on a photo, using a mask.
It wouldn’t work in my primary file, so I copied the layer that I wanted to a new file and it worked. Then I just copied the layer back.
I am not sure what is going on, but it does not appear to be consistant.
Don’t suppose you could send any good ale this way?!?!
Ale? I’m at it at the moment. This looks bad ‘cos I had a slap last night and insulted half the forums.
BBRRRRRRRRRR???????!!!!!!!!!!!
regards
Mark
P.S. German Beer mind, not UK as only the UK ale is good.
