– in 4 materials (clay versions included)
– 12 scenes
– 48 MacBook Pro 16″ mockups
– 6000 x 4500 px
I am trying to stroke a path, in this case a line segment with a start point and an end point created using the pen tool, but instead of a stroked line, all I keep getting are two stroked dots where the begining and end points of the line are.sounds like you’ve got the brush spacing turned off…try turning it on and adjusting it to get the effect you want. if you want a solid line start at 1%. also covered in the manual and help.
I have followed the directions and tried it many times but always the same result. I create the line, select it with the path selection tool then I select the paint brush, adjust the width of the brush and choose stroke path.
I would greatly appreciate a solution to this problem
-Dave M.
– in 4 materials (clay versions included)
– 12 scenes
– 48 MacBook Pro 16″ mockups
– 6000 x 4500 px
Nice and short text about related topics in discussion sections
