Views
271
Replies
1
Status
Closed
This question is tangental to the purpose of this group, but I thought I would I have the best chance of getting an answer here. I’m about half way through Bruce Fraser et al.’s book ‘Color Management’ – everything you’d want to know on the subject by the way – and was following the procedures to profile my monitor with my ColorVision Spyder Pro. I’m not able to fully adjust the monitor with precal. I ended up with brightness of 52 and contrast of 100 to get the luminance in range. I can’t adjust the RGB values since the connection is DVI. ColorVision says not to use precal with LCD monitors, but to set brightness and contrast to factory defaults. I haven’t been able find out what they would be for my Samsung SyncMaster 191t+. Is where I got with precal good enough or should I try to find out what the manufactures defaults are?
Curt
P. S. I know there’s a way to reset the monitor to factory defaults by pushing a combination of buttons. I can’t find out how to do that either. Samsung documentation is lacking.
Curt
P. S. I know there’s a way to reset the monitor to factory defaults by pushing a combination of buttons. I can’t find out how to do that either. Samsung documentation is lacking.
MacBook Pro 16” Mockups 🔥
– in 4 materials (clay versions included)
– 12 scenes
– 48 MacBook Pro 16″ mockups
– 6000 x 4500 px