Views
424
Replies
5
Status
Closed
Ok here is the deal, I have 4 Gigs RAM onboard. Dell 9100 with Pentium D processor. One of the reasons I upgraded from CS to CS2 is so I can supposedly gain access to all of the memory that I have on board, or at least up to the 3.5 Gig limit in CS2. Problem, I still only have access to the same 1.7+ Gigs I had reported available by CS. Anyone have any suggestions as to what I need to do to get access to this additional memory? Is this a Photoshop setup issue or do I need to change some setting in Windows to allow CS2 to access this memory or is this an issue related to the dual processor chip. As best as I can tell from Windows, at startup windows is using about 500 Megs of available memory as far as I can tell, so I should have right near the 3.5 Gigs memory available for CS2 use.
Any comments or suggestions greatly appreciated.
Later Larry
Any comments or suggestions greatly appreciated.
Later Larry
Related Tags
MacBook Pro 16” Mockups 🔥
– in 4 materials (clay versions included)
– 12 scenes
– 48 MacBook Pro 16″ mockups
– 6000 x 4500 px