Views
210
Replies
4
Status
Closed
I’ve often wondered about how PS applies feathering to a selection. For example, assuming I’ve made a selection and chose a feathering amount of 10 pixels, which of the following methods are used?
1. The 10 pixels is applied inside of the selection boundary.
2. The 10 pixels is applied outside of the selection boundary.
3. 10 pixels is applied to both inside and outside of the selection boundary.
4. 5 pixels is applied to each side of the selection boundary.
5. PS uses a different method not listed above.
One additional question, if I may. If you have a feathered selection, is there a way to un-feather it other than undo or editing the history state?
Thank you.
1. The 10 pixels is applied inside of the selection boundary.
2. The 10 pixels is applied outside of the selection boundary.
3. 10 pixels is applied to both inside and outside of the selection boundary.
4. 5 pixels is applied to each side of the selection boundary.
5. PS uses a different method not listed above.
One additional question, if I may. If you have a feathered selection, is there a way to un-feather it other than undo or editing the history state?
Thank you.
MacBook Pro 16” Mockups 🔥
– in 4 materials (clay versions included)
– 12 scenes
– 48 MacBook Pro 16″ mockups
– 6000 x 4500 px